ZMC432N Motion Controller User Manual V1.5
requirements on output of electric level can be achieved.
⚫
For the public end, please connect the "EGND" port on the IO power supply to the
"COM" terminal of the external input device. If the signal area power supply of the
external device and the power supply of the controller are in the same power supply
system, this connection also can be omitted.
⚫
Please wire according to wiring, don’t connect to all controllers’ EGND signals.
3.4.2.
Basic Usage Method
(1)
Please follow the above wiring instructions to wiring correctly.
(2)
After powered on, please select any one interface among the three interfaces
ETHERNET, RS232 and RS485 to connect to ZDevelop.
(3)
State values of relative input ports
can be read directly through “IN” command, also,
it can be read through “ZDevelop/View/In”. Please refer to “ZBasic” for details.
(4)
Latch function can be set and triggered
through “REGIST” instruction, in software,
use REG_INPUTS to configure. Please refer to “ZBasic” for details.
3.5.
OUT (Digital Output, PWM Terminal, Hardware
Comparison Output)
The digital output adopts 2 sets of screw-type pluggable terminals with a spacing of
Содержание ZMC432N
Страница 1: ......
