Zmorph 2.0 S, Руководство пользователя

Страница: 67 / 83

MAINTENANCE AND FUNCTION / TROUBLESHOOTING AND ADJUSTMENTS
67
Symptom: uneven layer height, cracks between layers.
Reason: uneven layer height, cracks between layers.
Solution: make sure that spool rotates freely.
Symptom: layers are shifted, machine loses position from time to time.
Reason: friction on one or two axis is too strong, or speeds are too high.
Solution: find cause of high friction.
Usually smooth rails are covered in sticky substances that prevent it from moving
freely. Clean them with soap and water,
Slow down travel speed, lower accelerations,
increase motor power to 1.6 or 1.7 in config file (alpha_current or beta_current values).
Symptom: layers are shifted, machine loses position from time to time,
blobs of plastic occur during print.
Reason: extruder toothed pulley might be too loose,
retractions don’t work properly.
Solution: tighten M2 screws in brass pulley (filament drive).
Increase Z lift value (to 0.3 - 0.5 mm),
nozzle then gets lifted every time it travels,
so it doesn’t collide with blobs of plastic.