Zmorph 2.0 S, Руководство пользователя

Страница: 22 / 83

GET STARTED / CALIBRATION
22
After setting the right temperatu-
re, you should move the nozzle to
the working areas 4 corners (black squ-
are)
and make sure that the clearance is
the same (as a paper sheets thickness).
Re-balancing the X-axis
made by adjusting vertical threaded rods on the side of the machine.
Turning only one of them, you can change the height of the nozzle at one of the ends
of the axis. Together with Z-endstop calibration, you can level entire X-axis.
This regulates the difference between the left and right half of the table.
A
If it’s not, regulation can be run in two ways:
Use:
Calibrate >> Check ...
To be able to turn the trapezoidal rods, you have to switch off the power,
or choose:
Move Axis >> Motors Off.
5