ZMIN X1, Руководство пользователя, Страница: 22 / 43

21
8010001002
X Series User’s Manual Chapter 2 Installation & Operation
Loading the Media
X Series printers can be operated in three different modes: Standard mode, Peel-off mode, or Cutting
mode.
In Standard mode, each printed label remains on the backing liner.
In Peel-off mode, each printed label is peeled away from the backing liner automatically.
In Cutting mode, the printer automatically cuts the label after it is printed.
Standard Mode
1. Push the left and right Top Cover’s Latch Button to lift the top cover. (see Figure 6-1).
2. Load a roll of media (labels facing up) on the Media Spindle, then slide the two Media Roll Guides
with their smooth sides toward the media onto the Media Spindle from each end until snug against
the media. If you are placing a roll of media with a 3
″ ID core, please slide the two Core Adapters
onto the Media Spindle first. (see Figure 6-2)
3. Insert them into the Media Compartment.
4. Corresponding to the scale on the Media Spindle, position the media roll in the middle of the Spindle.
5. Release and lift the Printhead Module.
6. Route the media as shown in Figure 6-3.
7. Slide the Media Guide to the edge of the media.
8. Close the Printhead Module and press down until it locks into place (see Figure 6-4).
9. Close the top cover and press the ‘Feed’ button to feed the media and ensure proper tracking. If the
printer does not correctly sense the top of each label, it may be necessary to perform the Calibration
Procedure in the Operation Basics section.
Peel-off Mode:
The loading guide will be provided with the peeler kit.
Cutting Mode:
The loading guide will be provided with the cutter kit.