ZMIN X1, Руководство пользователя, Страница: 15 / 43

14
8010001002
X Series User’s Manual Chapter 2 Installation & Operation
Loading the Ribbon
Notice:
(1) Make sure the ink side of your ribbon faces outwards. Always make sure the ink side of the
ribbon faces the media and NOT the printhead.
(2) The maximum width of the ribbon is 110mm. When using a ribbon roll with a width less than
110m, please place the ribbon roll in the middle of the Ribbon Spindle corresponding to the
scale.
(3) This section is not applicable to direct thermal printing.
1. Push the left and right Top Cover’s Latch Button to lift the top cover. (see Figure 5-1)
2. Pull the left and right Printhead Latch levers to release the Printhead Module.
3. Lift the Printhead Module to expose the Ribbon Supply Compartment. (see Figure 5-2)
4. Unwrap the ribbon roll pack and separate the ribbon roll and the core. (see Figure 5-3)
5. Slide the roll of Ribbon onto one of one Ribbon Spindle. (see Figure5-3)
6. Load the Ribbon Spindle into the printer and route the ribbon through the Printhead Module. (see
Figure 5-4)
7. Slide the ribbon take up core onto the other Ribbon Spindle. (see Figure 5-3)
8. Wrap the end of the ribbon around the ribbon take up core. (see Figure5-5)
9. Load the ribbon take up core into the Ribbon rewind Compartment. (see Figure5-6)
10. Rotate the Ribbon rewind wheel on the left of the core to take up the loose ribbon and tighten the
ribbon.
11. Close the Printhead Module and press down until it locks into place.