SA40
User Manual
P a g e
| 12
Copyright©2021 ZKTECO CO., LTD. All rights reserved.
1)
When the administrator card is directly swiped once, the access control device enters the
administrator mode.
2)
When the administrator card is swiped twice, the door sensor switches between the NO and NC
modes.
3)
When the addition card is directly wiped, it enters the batch adding user cards state.
4)
When the deletion card is directly wiped, it enters the batch deleting user cards state.
8. Add a Card-based User
Press *#administrator password
1
swipe the card
For example: *#1234
1
swipe the card
Note: You can swipe cards consecutively to add card-based users in batch and
press * to exit the state
.
9. Add a Password-based User
Press *#administrator password
2
enter a user password of 4-6 digits#
For example: *#1234
2
123456#
Note:
1)
The user password must contain 4-6 digits.
2)
After a password-based user is added, you can continue to enter the user password to consecutively
add password-based users, and
press * to exit the state
.
10. Add a Card-and-password User
You can add a card-and-password user by using two methods.
1)
Press *#administrator password
3
enter a user password of 4-6 digits#
swipe the card
For example: *#1234
3
123456#
swipe the card
2)
Press *#administrator password
3
swipe the card
enter a password of 4-6 digits#
For example: *#1234
3
swipe the card
123456#
Note: After a card-and-password user is added, you can continue to enter the user password to
consecutively add card-and-password users. You can either enter the password first and then swipe the
card or swipe the card first and then enter the password to open the door. You can
press * to exit the
state
.
11. Delete a User
You can delete a user by using three methods.
1)
Press *#administrator password
4
enter the user password# (You can consecutively enter the
password to delete multiple users.)
