Dual Loop Detector LD0l
User Manual
SW2
1
000
1
AB
.fl
LKl
T
3
ED
2
L
E
D l
LE
D3
C H
l
C 2
LK .
LK
6
S'N
l
3.6
lnternal Link Selection
There are 3 link positions located inside the LD01 which are used to alter the output relay configuration of the
detector. The links have been placed inside the unit to avoid incorrect operation due to selection by an
unauthorised operator.
L1
K5
,
L
IK
6
[C
H l .
C
2)
mm
PU.SE
A8-lOGfC:
4
Front Panel lndicator
While the detector is tuning, the Channel LEO will indicate the "mode" status of the detector.
1)
Any Channel output operating in the presence or pulse modes will come on and extinguish when the
system is tuned.
2)
When the AB Logic mode is selected, the Channel LEOs will alternatively flash slow and extinguish when
the system is tuned.
lf a loop fault exists the Channel LEO will come on and flash indicating a fault. lf the fault is self-healing the
detector will continue to operate.
The channel LED will also glow whenever a vehicle is detected passing over the inductive loop.
The Power LED at the top of the unit will remain on to indicate that the unit is powered.
Page
110
Copyright©2020 ZKTECO CO., LTD. AII rights reserved.
