ZKaccess C3-100, Инструкция по установке и эксплуатации

Страница: 9 / 37

Instructions for Installation and Use of the C3­100/200/400 Control Panel
6
Output load: working voltage AC ≤ 30V, rated current ≤ 8A; DC ≤ 36V, rated
current ≤ 5A.
C­type electronic lock relay output terminal: 10A contact current, 12V DC,
with LED status indications.
Output terminal of the auxiliary relay: 2A contact current, 30V DC, with LED
status indications.
With detachable connection terminals made of alloy­steel non­magnetic flange
materials.
Outline dimensions of the control PCB: 160mm (length) × 106mm (width) for
C3­100/200; 218mm (length) × 106mm (width) for C3­400.
Mounting hole dimensions of the control PCB: 147.32mm (length) × 91.44mm
(width) for C3­100/200; 203.2mm (length) × 106mm (width) for C3­400.
External box dimensions: 345mm × 275mm × 70mm.
2.3 Control Operator Panel Indicators
When the C3­100/200/400 is powered on, normally the POWER indicator (red) is lit
constantly, the RUN indicator (green) flashes (indicating the system is normal), and
other indicators are all off.
Except the cases as follows:
1. LINK indicator (green): indicates proper TCP/IP connection if it is lit
constantly;
2. ACT indicator (yellow): indicates transmission of TCP/IP data if it flashes;
3. TX indicator (yellow): indicates sending of 485 data if it flashes;
4. RX indicator (green): indicates receiving of 485 data if it flashes;
5. Lock indicator (green): indicates unlocking if it is lit constantly (if the
auxiliary output indicator is lit in green constantly, it indicates the auxiliary
device is enabled);
6. CARD indicator (yellow): indicates input of Wiegand signal if it is lit.