Please read this instruction carefully before you
make any operation on your vehicle. This device
contains battery product that may cause personal
injuries. If you are uncertain or have questions
about this device, please consult your dealer or
reseller before use. THIS IS FOR 12V SYSTEM
ONLY, DAMAGES CAUSE BY IMPROPER USE
WILL SOLELY BE USER’S RESPONSIBILITIES.
Do not crank start your vehicle for more than 5
sec, or longer. This will damage your vehicle
starting system and over heat the JUMP START
LiPo battery. As a precaution, please allow
JUMP START to rest for 30 sec., before starting
your vehicle.
MUST READ:
MUST DO:
1. WARNING
•Do not use the device in the rain or wet conditions. Unit is not
waterproofs. The functionality of device might be affected.
•Keep the device away from where the children can access.
Never attempt to alter or disassemble the product. If there is
a problem with the product please contact your dealer for
further assistance.
•Do not allow metal to come in contact with the battery poles.
It may spark or short-circuit the battery and cause an
explosion.
•Stop using the jumpstart when you hear the alarm or cannot
turn on the JUMPSTART. The reason may be from:
①
The jumpstart device voltage is less than 9V - Charge the
jumpstart to prevent battery failure.
②
The device temperature is higher than 140˚F (55˚C) - Cool
the jumpstart to at least 104˚F (40˚C).
③
The jumpstart is connected backwards, incorrectly
connected or short connected. Correctly connect the
clamps.
•If CAR battery is less than 2V, there is no safety check to
prevent incorrect polarity hook up.
Before using the JUMPSTART, read and follow the
instructions carefully. Also pay close attention to
the cautionary statements on the vehicle battery and
any other equipment.
NOTE:
As a safety measure, there is NO VOLTAGE present
at the clamp ends. The product automatically detects
when it is hooked up correctly to a battery, LCD
displays the voltage of vehicles battery if the
voltage is within 4V~14.2V. Only if
JUMP START
button is pressed
,
will then deliver the voltage to the
clamps.
1
