Zipsnip RC2602, Руководство пользователя

Страница: 8 / 24

Heavy-Duty, Self-SHaRpening CoRDleSS CutteR eng
8
teCHniCal Data
Charger 120V~60Hz
Voltage 3.6V
No load speed 260/min
Material capacity 1/4˝
Charging time 3-5hr
Machine weight 1lbs
opeRating inStRuCtionS
note: Before using the tool, read the instruction
book carefully.
aSSeMBly
ReMoving anD inStalling tHe BlaDe (See a1,a2)
Note: When changing the blade , you must insert an
object (such as a small slotted screwdriver) into the
spindle slot(13) to lock in place. (See A1)
1) Rotate blade screw counter clockwise with a slot tip
screwdriver and remove the blade screw.
2) Slide the blade away from the upper guard and
remove blade.
3) Slide new blade under the upper guard with beveled
edges facing you.
4) Align hole in blade with hole in the blade shaft,
replace screw and securely tighten the blade screw
clockwise.
opeRation
1. on / off SwitCH (See B)
Your switch is locked off to prevent accidental starting.
Depress lock off button then on/off switch and release
lock off button. Your tool is now on. To switch off just
release the on/off switch.
2. CHaRging tHe tool
The battery charger supplied matches to the battery
installed in the machine. Do not use other battery
chargers.
The battery is protected against deep discharging.
When the battery is empty, the machine is switched off
by means of a protective circuit: the blade will no longer
move.
In a warm environment or after heavy use, the battery
pack may become too hot to permit charging. Allow
time for the battery to cool down before recharging.
3. CHaRging
Plug charger plug into a suitable power outlet and
afterwards plug your tool into the battery charger. The
charging indicator (red) will illuminate at this time.
The charger indicator will turn green when charging
is complete. Then unplug the charging plug from the
wall socket and then remove the tool from the battery
charger.
important:
During the charging procedure, the handle of the
machine warms up. This is normal.
When not using for extended periods, disconnect the
battery charger from the socket.
Do not use the machine during the charging procedure.
Maintain toolS witH CaRe
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust.
Cleaning
waRning! To avoid accidents, always
disconnect the tool and/or charger from the
power supply before cleaning. The tool may be
cleaned most effectively with compressed dry air.
always wear safety goggles when cleaning tools with
compressed air.
When cutting, material residue can accumulate under
the upper guard. Remove blade and clean upper guard
regularly using a brush or lightly moistened cloth.
Ventilation openings and switch levers must be kept
clean and free of foreign matter. Do not attempt to clean
by inserting pointed objects through opening.
Caution: Certain cleaning agents and solvents
damage plastic parts. Some of these are:
gasoline, carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents that
contain ammonia.
tRanSpoRt
The battery has effective protection against internal
overpressure and short circuiting as well as measures
for prevention against forced rupture and dangerous
reverse current. The lithium equivalent contents
contained in the battery is below the spilling limit
values. Therefore, the battery is not subject to the