MK-100377 Rev. A
16
Z I PP I E V O Y A GE
O. KNEE ANGLE ADJUSTMENT (MODERATE)
WARNING
Always stabilize the mobility device before performing this action.
•
Rotate the front casters until they point forward.
•
Engage the parking brake.
Knee angle adjustment (Moderate Seating Shell)
a. Be careful to avoid pulling or crimping any life support tubing that may be attached to
the child. This adjustment can create a pinch point, so be careful to remove any
obstruction, and/or clothing that could get stuck in this area.
b. Release the quick release lever(A) and adjust the Knee angle to the desired angle.
c. Fasten the quick release lever properly after every adjustment
2
4
VIII. USE AND MAINTENANCE
2
4
A
N.KNEE ANGLE ADJUSTMENT (ADVANCED)
WARNING
Always stabilize the mobility device before performing this action.
•
Rotate the front casters until they point forward.
•
Engage the parking brake.
Knee angle adjustment
(A
DVANCED
)
a. Be careful to avoid pulling or crimping any life support tubing that may be attached to
the child. This adjustment can create a pinch point, so be careful to remove any
obstruction, and/or clothing that could get stuck in this area.
b. The adjustment is made from the front of the device. Depress both legrest pivot but-
tons (D) simultaneously, and adjust to desired angle.
c. Release the buttons and allow the legrest to lock into place.
2
3
23
D
M.RECLINE ADJUSTMENT
WARNING
BEFORE using the recline adjustment, always check that the mobility device is completely
unfolded and in the locked position, and that all four wheels are locked in place. Be careful
to avoid pulling or crimping any life support tubing that may be attached to the child. Always
remember to stabilize the mobility device before performing this action.
•
Rotate the front casters until they point forward.
•
Engage the parking brake.
•
If equipped with shoulder harness, loosen the shoulder straps to allow room for the
recline.
Recline adjustment
a. Remove the safety pin from the recline lever. From behind your mobility device, grasp
the recline lever (C). Squeeze the lever then pull on the back support area. (The back
should move independently of the seating support and footrest). When desired angle
adjustment has been reached, release the handle and gently pull on the seating shell to
make sure it is locked in the new position, and replace the safety pin.
b. This adjustment can change the balance of the device slightly so it is good to check
that there is no danger of tipping with the new setting.
c. If equipped with shoulder harness, re-adjust the straps for proper fit.
22
22
C