ASSEMBLY
Z.I.P.P.E.R Maschinen Austria
www.Zipper-maschinen.at
Seite31
ZI-RMM94H
14.1.4
Remove tire from the rim
Place the tire on the turntable (6). ATTENTION : In asymmetric drop center rims set the tire on
so that the flatter side is up.
Do all the way to the outside jaws according to drive the control pedal (2).
Note: There are different types of jaws according to the different fields genotypes . For alumi-
num rims , you should use the 4 jaw protectors .
In the event that you want to stretch the rim from the inside out , shut the jaws together first ,
put the tire on the turntable and stand on the pedal (2) to clamp the rim.
In the event that you want to stretch the rim outside , take the jaws apart ( 2 -3cm from the
edge of the rim away), the tire place centered on the turntable and contact to tension the
wheel and pedal (2).
Depress the control pedal (2), making sure that the 4 jaws (7) Tighten the wheel on the rim
flange.
Press the control pedal (3) and thus the pivot arm in working position, press the mounting rail
(11) down so that the mounting head (7) 1-2mm away from the edge of the rim to protect the
rim.
Secure the work position by pressing the locking button
A
- described in 7.1.1 -
See Figure D:
Pull the outer tire bead with the tire iron over the mounting head.
With the auxiliary mounting arm (15), you can use the pressing plate (16) or of the press roll-
er (22) the tire bead into the rim to push the tire bead easy to lift over the rim flange.
Activate the control pedal (4) to rotate the turntable clockwise until the tire was completely
drawn over the rim. To prevent damage to a possibly existing hose, position the wheel so that
the valve is about 10mm from the mounting head.
Siehe Figure E:
First, remove the hose, if available.
Now lift the mounting iron the bottom bead over the mounting head.
Depress the pedal (4) to solve the lower tire bead and thus the whole tire from the rim.
Depress the pedal (2) to open the jaws and take the rim from the turntable down.
NOTE:
For subsequent mounting of a tire, the rim remains on the turntable
.
14.2
Frosting rim
Check that the tire and rim fit in size to each other!
Tension. Rim just as when removing the tire If you want to frost the same rim new, let
clamped the rim.
Lubricate the tire bead and the rim edges with a lubricant or soapy water.
Place the tire on the rim so that the left side is higher and move the pan back into working
position.
See Figure F:
Position the tire so that the tire bead is higher than the left (Fig. 1 F), however, but under the
right side (Fig. 2 F) of the mounting head.
With the auxiliary mounting arm (15) you can push the tire bead into the rim to easily lift the
tire bead to the mounting head over the rim flange with the press plate (16) or of the press
roller (22).
Activate the control pedal (4), the inner tire bead is pulled under the outer edge of the rim.
Insert the inner tube, if available. This should not interfere with the installation!
