OPERATION
ZIPPER MASCHINEN GmbH
www.zipper-maschinen.at
Seite 35
Mobile Motorsense / mobile brush cutter ZI-MOS 100-4T
Seite 35
Pull out the cable-pull starter handle (arrow) until
resistance is felt and then pull rapidly by.
Run the cable pull-starter handle slowly to the rope
guide back as soon as the engine starts
Adjust the throttle, how you need it now (depends on the grass density and vehicle speed
from). (In the first 10 hours you should not unnecessarily cut with constant full throttle
whenever possible - this protects the drive motor and ensuring the extended life).
14.2.2
Stop machine
Set the machine to a place, has already been mowed to the first.
Move the throttle lever to the idle position.
Press the
ON / OFF
switch to
"OFF"
(Fig.
B
)
14.2.1
Adjusting the cutting side
For the convenient and safe free cutting with the cutting
head along fences and other boundaries, the cutting
head can be swiveled left or right side!
By loosening the clamp screw and rotate the cutting unit
in the desired direction.
After that, tighten clamping screw again.
14.2.2
Adjustment of the cutting angle
For sloped surfaces of the cutting head with the angle adjustment knob (Fig. 1) can be
swiveled.
Turn the angle adjustment knob to the left and turn the cutting unit to the desired slope.
By the turn angle adjustment knob clockwise to the cutting unit is clamped.
