ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
23
ZI-STE6700DH & ZI-STE7500DSH
13.3
Operation
13.3.1
Starting the engine:
▪
Open fuel tap.
▪
Set the speed control to position „RUN“
.
▪
Electronic starter:
-
Set ignition key to position "ON". After waiting 1-2 seconds, turn the ignition key to
position “Start”.
-
Release ignition key as soon as the engine has started.
-
If the engine does not start within ten seconds, stop the starting process.
-
Wait at least 30 seconds, before attempting a new start.
▪
Recoil starter:
-
Pull the rope hard and fast.
-
Pull the rope all the way out.
-
Use two hands if necessary
-
Possible reasons for starting difficulties:
▪
Cold weather
–
if necessary, use starter-spray in the intake nozzle.
▪
Low battery, low acidity level
–
contact a qualified person or, with appropriate experience,
refill distilled water yourself.
▪
Low oil (refill oil)
▪
Air in fuel-pipeline.
13.3.2
Stop the engine
N O T I C E
•
Disconnect all electronic equipment from the generator before switching off the
engine.
•
Allow the device to continue running for approx. five minutes (5 min) after a
long period of use. This helps the motor to cool down.
Turning off procedure
▪
Set circuit breaker to position "OFF".
▪
Turn ignition key to the left into position "OFF".
▪
Close fuel tap.
13.3.3
Electrical consumers
When the generator is running on nominal speed, electrical consumers can be connected.
When operating several consumers, you should first connect the consumer with the higher inrush
currents requirement! If no problem occurs, more consumers can be connected.
If the generator shuts down, the required power was probably too high.
N O T I C E
Make sure, the max. power output of the generator is not exceeded.
If the voltage (see voltmeter) is too high or too low, adjust the speed level. If a problem occurs,
stop the generator and take care of the problem.
At the DC-module (12V), a maximum amount of 8.3 A current is possible.
C A U T I O N
Pay attention to correct connecting:
Red connection: + terminal
Black connection: - terminal
