19
Note long bevel sanded in front of ski.
Rear of assembled ski.
Drill in the center of this hole.
Sand a sharp bevel on the front of the ski
bottom sheet, so that it blends into the tub
bottom. Do not glue the ski to the tub yet.
Servos
Bolt the rudder in place. This should be as
far to the right as possible, and be sure that
you have at least ¾ inch of rudder below
the bottom of the ski.
Make a mark on the transom where the
rudder pushrod will exit.
Sight this from behind the boat.
(see drawing).
Drill a ¼ inch hole, inboard of your mark.
