Zipforce ONE, Руководство пользователя

Страница: 35 / 40

15
IMPORTANT INFORMATION
• It is very important that the bicycle wheel the Zipforce is fitted to is attached to the bicycle. Check this before riding.
• In the raised position, the distance between the wheel and the Zipforce drive wheel must be a maximum of 3mm, see
image 7, otherwise there is a great risk that the drive wheel will slip when the engine is screwed into the drive position.
There will not be enough grip in the lowered position if the initial distance is too great. Improper fitting will lead to excess
wear of the drive wheel.
• NOTE! Do not ride with the Zipforce turned off while it is screwed down onto the tyre. You must also not start cycling and
then turn on the Zipforce.
• Only use the Zipforce on bicycles with front and rear brakes that are in good working order.
• Only use the Zipforce on bicycles with the right type of tyres, go to: zipforce.io/faq/
SCOPE AND LIMITATIONS OF USE
• The Zipforce is mainly intended for use on asphalt or gravel roads.
• Never screw down the clamping screw to lower than the point where it is just touching the unit’s cover. Otherwise, the
plastic cover may be damaged.
• The Zipforce may become hot during intensive use. The unit has built-in protection against overheating, causing
temporary power loss when the protection is activated.
• Be careful when back-pedalling or using regeneration on slippery roads.
• Only install the Zipforce on robust bicycles with well-functioning rear and front brakes. The bicycle must comply with the
standard SS-EN ISO 4210-4, 6, 8:2014.
• If you have or need a bicycle basket, visit: zipforce.io
CARE ADVICE
• Keeping the clamping screw lubricated prevents it from jamming in the locking mechanism. Grease the screw and be sure
to grease the part that protrudes out under the unit.
• Wipe the motor with a cloth, especially after use in rain and dirt.
• If you are going to put the Zipforce into winter storage, wipe it with a slightly damp cloth and charge it to around 60%.
• The Zipforce should always be turned off when not in use. When transporting it, be careful not to damage the buttons and
clamping screw.
Stop charging in the following situations:
• If the battery isn’t reaching full charge after 6 hours, see the
troubleshooting guide.
• The Zipforce gets hot (> 50°C) when charging.
A bicycle helmet must be used when cycling!
Do not use a pressure washer on the Zipforce, as it may introduce gravel, dirt
and water into the electronics and mechanical parts.