Zipforce ONE, Руководство пользователя

Страница: 30 / 40

10
9
FITTING THE PAS SENSOR SET
The pedal sensor captures when you are pedalling and decides when the Zipforce
should assist. It is important to ensure that the pedal sensor ring does not wobble or
sit crooked or loose! Adjust using the sheet metal bracket until the pedal sensor ring is
completely straight. If the pedal sensor or pedal sensor ring is not straight, the sensor
will not pick up the signals and the Zipforce will then operate poorly or not at all.
1. Bend the sheet metal bracket so that it fits along the pedal arm and so the sensor
ring is straight, see images 1a and 1b.
a. bend the sheet metal bracket along line a.
b. bend the sheet metal bracket along line b. The pedal sensor should now sit
completely straight. See image 1b.
2. Bring the two crescent-shaped parts of the pedal sensor ring together. See image
10.2a. It is important to ensure that the pedal sensor ring is straight and stable. If
the pedal sensor ring does not fit around the axle, you can cut away every other
small spike inside the crescent. See image 10.2b.
3. Fasten the metal ring around the pedal
sensor ring by pushing it into place in
the groove. See image 10.3.
4. Bend the bracket to fit along the pedal
crank arm (c) and that the pedal sensor
ring is completely straight.
5. Secure the sheet metal bracket with
cable ties around the pedal crank arm.
Tighten the cable ties and make sure
that the ring is stable. See image 10.4.
1a. 1b.
a.
b.
c.
PAS sensor set