5
805757 v1.05 06.21 Miniboil Install Instructions
WARNINGS AND PRECAUTIONS
!
Installation environment considerations
This unit is intended for indoor use only and should never be installed
outdoors or exposed to the elements of nature. This unit must not be
positioned in an area that may be cleaned by a water jet. This unit must
not be cleaned by a water jet.
Technical specification
Installation requirements
MODEL
Miniboil BA, Miniboil BO
Capacity
1.8 Litres
Power rating
1500 Watts
Width x Depth x Height (mm)
212 x 269 x 338
Weight (dry)
6.5 kg
Weight (full)
8.3 kg
Before installing ensure that the following have been provided at the
installation site:
• Sufficient space in the cupboard to install the command centre
in accordance with these Installation Instructions.
NOTE: Allow clearance of 50 mm around all sides and 200mm
above the command centre for air circulation.
• A water supply connection with isolating valve inside the
cupboard within reach of the 750 mm flexible connection and
positioned so that the connection point and the stop cock will
not be obstructed when the command centre is installed.
• Power supply 220-240 Volt AC, for connection to the appliance
via a 10 amp G.P.O.
• Cold water supply with a minimum working pressure of 150 kPa
and a maximum working pressure of 700 kPa connected via an
isolation valve.
• A 350kPa pressure limiting valve/DNR is supplied with the filter
kit and must be installed.
IMPORTANT! Do not proceed with the installation if these
requirements are not met.
