10
805757 v1.05 06.21 Miniboil Install Instructions
Sleep mode (for BA model only)
The unit can be set to Sleep mode to save energy. If Sleep mode is
enabled, the unit will switch to Sleep if it has not been used for two
hours. The water temperature will be maintained at 64 °C. Operation
of the tap during this time will wake the system from sleep and the
water will start heating up again. Boiling water is available as soon as
the red LED shows a steady light.
Press the BLUE lever and the SAFETY button and hold them for about 5
seconds to enable or disable Sleep mode.
The red LED and the white LED will flash simultaneously to confirm
that Sleep is enabled. They will flash alternately to confirm that Sleep is
disabled.
Long period of non-use
Note: In ambient / warm water, microorganisms can multiply
faster. It is recommended to leave your drinking water system
switched on even during long periods of non-use.
If you still want to shut down your drinking water system for an
extended period of time, proceed as follows:
1. Turn off the water supply.
2. Use the tap to dispense ambient and hot water until no more water
flows to empty the system.
3. Disconnect the appliance from the power supply.
After prolonged non-use
1. Reconnect the water supply. Pay attention to any leaks.
2. Reconnect the appliance to the power supply.
3. After non-use of several days: Drain at least four litres of ambient
water from the fitting. If necessary collect the water in a suitable
container. As soon as the LED in red lever lights up continuously,
drain hot water. Repeat this process until the LED flashes again.
CAUTION! Hot water will be dispensed.
4. The appliance is now ready for use.
Operation
A font kit is available for this product, sold separately as an accessory.
For details of the available font kits, please contact your Zip customer
service provider. The font installation instructions and mounting
template are supplied with the font kit.
Part No. 90915Z00: Font Kit, Chrome
Font installation
Activate / deactivate sleep mode
(BA model):
Press the blue lever and the Safety
button and hold them for about
five seconds.
LEDs light up simultaneously when
sleep mode is activated.
LEDs light up alternating when
sleep mode is deactivated.
