Page 7 of 12
Zip CT2/140, DOMCT1- Installation & operating instructions - June 2015 v1.01
Operation
Commissioning
ChillTap
®
Extra
The lever on the right is used for chilled filtered water and the other, on the left, is
used for ambient filtered water.
Chilled water is obtained by pulling the lever on the right forward, The water is
chilled by a refrigeration unit fitted within the chiller unit, under the sink.
Chilled water can be obtained within the rated capacity, for as long as the lever is in
the ON (horizontal) position. Ambient water is obtained in the same manner as the
chilled water, by pulling the lever on the left forward, to the horizontal position.
When finished dispensing water, both levers automatically return to the OFF (vertical)
position once finger pressure has been removed.
Commissioning
Secure all pipes and cables. After the system is correctly installed and connected,
turn the incoming mains cold water supply on. Check all connections for leaks.
Repair as necessary, again turn the incoming mains cold water supply on and then the
mains electricity supply.
The chiller unit takes up to 20 minutes to chill it’s contents to the rated temperature,
depending on the ambient temperature of the water.
Following installation, the chiller system will contain air, which needs to be purged.
To purge the system of air follow the instruction in the Filter replacement section,
page 8.
Dispose of the packaging wisely.
Pull
