13
Installation instructions & user manual
9120-34379 v1.20 Okt 2022 - ZIP DCX Next
Technical support
Tel: 0345 6 005 005 email: [email protected] www.zipwater.co.uk
Note: If you install this instantaneous water heater in exchange for a conventional
instantaneous water heater, there is generally no need to drill holes for the wall brack-
et, in this case step 2 would not be necessary .
Thoroughly rinse the water supply pipes before installation to remove soiling from the
pipes.
1 . Using a 12 mm hexagon socket screw key, screw the screw-in nipples into the wall
connections . The seals must be fully screwed into the thread . After tightening, the
double nipples must protrude by 12 – 14 mm .
2 . Hold the included mounting template on the wall and align it so that the holes in the
template fit over the double nipples . Mark the drill holes according to the template
and drill them using a 6 mm drill . Insert the included dowels .
3 . To open the appliance pull down the faceplate and unscrew the main hood screw .
Lift the hood carefully, remove the plug from the control panel and note the posi-
tion of the plug .
4 . Loosen the knurled nut of the wall bracket, remove the wall bracket and screw it on
the wall . Offset tiling or uneven surfaces can be compensated by up to 30 mm with
the aid of the spacers supplied . The spacers are fitted between the wall and the wall
bracket .
4. Installation
Note: Fasten the screw nuts with caution, to avoid damage to the valves or the piping
system.
• As shown in the illustration, screw the cold water connection piece with the union
nut and the ½ inch seal onto the cold water connection .
• Screw the hot water connection piece with the union nut and the ½ inch seal onto
the hot water connection .
Installing connection pieces
Installing the wall bracket
cold
warm
• Put the water flow limiter “
D
” into the hot water connection piece . The O-ring must
be visible
D
