Zio WLB5254AIP/X11, Руководство пользователя

Страница: 45 / 69

X11 Wireless Broadband Router User manual
Page 45 of 69
z
Physical Address Clone : Your ISP may require a particular MAC address
in order for you to connect to the Internet. This MAC address is the PC’s
MAC address that your ISP had originally connected your Internet
connection to. Type in this MAC address in this section to replace the WAN
MAC address with the MAC address of that PC (you have to be using that PC
for the Clone MAC Address button to work).
z
MTU : MTU is the Maximum Transmission Unit. It specifies the largest
packet size permitted for Internet transmission. Enter your MTU number in
the text-box to set the limitation. The recommended size, entered in the
Size field, is 1496. You should leave this value in the 1200 to 1500 range.
z
DNS : Check "DNS" and enter the IP address to specify DNS server for LAN
DHCP server.
z
Click “Apply” to save these settings with the Router. The System will apply
the new settings and start rebooting right away. After reboot, the Wireless
Router will enable these settings with the Router.
6.5 LAN Setup
6.5.1 LAN Setup
The Wireless Broadband Router communicates with the wired/wireless clients
through its LAN port. The LAN configuration page allows you to define the
private IP address and DHCP server settings over the LAN interface.
Figure 35
z
I P Address/Subnet Mask : Enter the IP address and subnet mask for the
Wireless Broadband Router LAN port. All local wired/wireless devices
communicate with the device through this port. It is also the IP address of
the Web-based Configuration Utility. By default, the IP address and subnet
mask of the LAN port is 192.168.10.1 and 255.255.255.0 respectively.
z
DHCP Server : The DHCP server can be ON or OFF in this screen. If you
choose to set this device as a DHCP server, then it will assign IP addresses
to its clients. The DHCP pool range is also changeable.