SW32V
11820-0701-01
Page
7 / 22
www.ziehl.de
7
Important Notice
WARNING
Hazardous electrical voltage!
Can lead to electric shock and burns.
Before starting work, switch plant and device voltage-free.
The flawless and safe operation of a device requires that it is shipped and stored appropriately,
professionally installed and put into operation and operated according to its intended use.
Only people who are familiar with the installation, commissioning and operation and who have
qualifications corresponding to their job are permitted to work on the device. They must comply with the
contents of the operating instructions, the notices attached to the device and the relevant safety
regulations for constructing and operating electrical plants.
The devices are built and certified in accordance with EN 60255 and leave the factory in a safe and
technically flawless condition. To maintain this state you must comply with the safety regulations indicated
with "Caution" in the operating instructions. Non-compliance with the safety regulations can lead to death,
bodily injury or property damage on the device itself and on other devices and equipment.
If the information in the operating instructions is insufficient at any time, please contact us directly or
contact the representation responsible for you.
Instead of the industrial norms and stipulations stated in the operating instructions and applicable in
Europe, you must comply with the valid and applicable regulations in the country of utilisation if the device
is used outside of the area of application.
Caution! If the operating current execution is programmed for all relays, a failure
of the control voltage or the device will not be detected.
When using as a monitoring device, the operator must ensure that this error is
detected through periodic performance tests.
We recommend programming and correspondingly evaluating at least one relay
in closed-circuit (idle) current execution.
8
Mounting
The device can be mounted:
•
Distribution board or switch cabinet on 35 mm rails according to EN 60715
Comply with the maximum permissible temperature when installing in a switch cabinet. Ensure
sufficient clearance to other devices or heat sources. If cooling is inhibited, e.g., through close
proximity to devices with increased surface temperature or interference with the cooling-air
current, the permissible ambient temperature is decreased.
Caution!
Before you apply mains voltage to the device, make sure that the permissible control
voltage
Us
on the side rating plate matches the mains voltage connected to the device!
!
!
