ZIEHL-ABEGG ZETADYN 3BF, Оригинальная инструкция по эксплуатации

Страница: 142 / 204

Error no. Error text Error cause M S
504 ENC: Sig.Int.
Error:
At target speed of >10 cm/s, inverter does not receive an encoder signal
Remedy:
check motor connections (U
R
U; V
R
V; W
R
W),
Brake not closed during start,
Check the motor data
Check the encoder connection
Increase the "SPD_KP" parameter in the "Control system" menu,
● ●
505 MB/ENC fault
Error:
At target speed of >10 cm/s, inverter does not receive an encoder
signal
Additional information:
Motor current in ampere
Remedy:
check motor connections (U
R
U; V
R
V; W
R
W),
Brake not closed during start,
Check the motor data
Check the encoder connection
Increase the "SPD_KP" parameter in the "Control system" menu,
● ●
506 X_ENC15:Discon.
Error:
Interruption of the encoder signal during travel
Remedy:
Check encoder connection
Switch frequency inverter off and then back on
515 v > 110% V*
Error:
Actual speed is
≥
110% of the nominal speed V*
Remedy:
Check whether the car counterweight is pulling up,
Check motor data in the "Motor name plate" menu,
Check the resolution type in the "Encoder & BC" menu,
Check the "SPD_KP" parameter in the "Control system" menu,
● ●
516 v > 150% V*
Error:
Actual speed is
≥
150% of the nominal speed V*
Remedy:
Check whether the car counterweight is pulling up,
Check motor data in the "Motor name plate" menu,
Check the resolution type in the "Encoder & BC" menu,
Check the "SPD_KP" parameter in the "Control system" menu,
● ●
518
519 Speed too low
Error:
The actual speed deviates from the target speed by -15%
Remedy:
Check encoder connection
Check the encoder impulses in the "Info" menu, page 11,
Check the brake lifting
Check motor data in the "Motor name plate" menu,
Check the resolution type in the "Encoder & BC" menu,
Increase "SPD_KP" ampli
fi
cation in the "Controller" menu
● ●
520 Wrong direction
Error:
Machine moves more than 12 cm in the wrong direction
Remedy:
Check encoder connection
Check the encoder con
fi
guration in the "Encoder & BC" menu
check the motor connections (U
R
U; V
R
V; W
R
W)
Inverter size too small
● ●
522 ENC: Dif. Pos
Error:
Too large positive difference in the encoder counter level between two
scan steps. The limit value equals 2 times the installation rated speed
Remedy:
Check whether the car counterweight is pulling up,
Check motor data in the "Motor name plate" menu,
Check the resolution type in the "Encoder & BC" menu,
Check the "SPD_KP" parameter in the "Control system" menu,
Check the motor connection
● ●
523 ENC: Dif. neg
Error:
Too large negative difference in the encoder counter level between two
scan steps. The limit value equals 2 times the installation rated speed
Remedy:
Check whether the car counterweight is pulling up,
Check motor data in the "Motor name plate" menu,
Check the resolution type in the "Encoder & BC" menu,
Check the "SPD_KP" parameter in the "Control system" menu,
Check the motor connection
● ●
Original operating instructions
ZETADYN 3C
Error diagnosis
R-TBA08_03-GB 1619 Part.-No. 00163322-GB
142/204