ZIEHL-ABEGG ZETADYN 3BF, Оригинальная инструкция по эксплуатации

Страница: 138 / 204

13.5.6 Error 3xx
•
Error before trip start
Error no. Error text Error cause M S
301 MOP: Timeout
Error:
No communication between the application processor and the motor
management processor during start due to an error during the update
Remedy:
Perform a software update
● ●
303 MOP: SW-Error
Error:
Software error message in the motor management processor
Remedy:
Perform a software update
● ●
304 MOP: HW-Error
Error:
Hardware error message in the motor management processor
● ●
305
306
ADC calibration??
Error:
Zero point offset in the motor current detection (analogue digital con-
verter) is outside the tolerance
Remedy:
Replace defective shunt module
●
307 Iu Iv Iw > 1.0A
Error:
Defective current measuring the phase U, V or W
Remendy:
Check the connector of the Shunt-Modul
Current sensors are defekt
● ●
310 No abs.enc
Error:
The connected absolute encoder is not detected (when switching on the
inverter no the absolute encoder was not connected)
Remedy:
Check encoder connection
Switch frequency inverter off and then back on
Parameter im Men
ü
"Encoder & BC"
ü
berpr
ü
fen
●
315 EnDat: HW-error
Error:
EnDat encoder delivers error
●
316 EnDat: Resolution
Error:
Con
fi
gured resolution in the EnDat encoder does not match the encoder
resolution
Remedy:
Enter the correct encoder resolution in the "Encoder & BC" menu
●
320 ENC: Error-start
Error:
Con
fi
gured sinusoidal encoder was not detected
Remedy:
Check connection
Check the encoder type; possibly connect a square wave encoder
● ●
321 EnDat: ULP-error
Error:
While starting, an error was read out from the EnDat encoder. Error is
stated as a code:
0: defective encoder power supply
1: no SSI communication
2: Encoder illumination defective
3: defective signal amplitude
4: Positioning error
5: defective sine evaluation
Remedy:
Check the connection, Check the encoder
322 EnDat: Com-Fehler
Error:
During start, malfunction in communication to EnDat encoder; absolute
value could not be read out
Remedy:
Check the encoder,
Check rotary encoder line
Check the encoder con
fi
guration in the "Encoder & BC" menu
324 SSI: Ack-Error
Error:
During start, malfunction in communication to SSI encoder; absolute
value could not be read out
Remedy:
Check the encoder,
Check rotary encoder line
Check the encoder con
fi
guration in the "Encoder & BC" menu
325 SSI: Timeout
Error:
During start, malfunction in communication to SSI encoder; absolute
value could not be read out, encoder does not reply
Remedy:
Check the encoder,
Check rotary encoder line
Check the encoder con
fi
guration in the "Encoder & BC" menu
327 ENC: Read-Error
Error:
During reading out the position of the absolute encoder (position will be
read out repeatedly) different values will be read.
Remedy:
Check the encoder,
Check rotary encoder line
Check encoder connection (e.g. shielding)
Original operating instructions
ZETADYN 3C
Error diagnosis
R-TBA08_03-GB 1619 Part.-No. 00163322-GB
138/204