ZIEHL-ABEGG ZA dyn 4C, Оригинальная инструкция по эксплуатации, Страница: 108 / 224

Parameter Designation Value range
Factory set-
ting
CHN1
Con
fi
guration of the measuring channels 1-4 with analog meas-
urement values
1:
Setpoint for travelling speed [m/s]
3:
acutal speed [m/s]
6:
Internal status (frequency inverter status)
16: fl
ux build-up current [A]r
26:
motor current [A]
27:
motor voltage [V]
31:
temperatur power section [
°
C]
49:
covered total travel distance [m]
62:
residual path by the control system [mm] (only wirh DCP2 or
DCP4)
119:
Capacity of the Brake-Chopper / Brake resistor
142:
Intermediate circuit voltage [V]
143:
torque build-up current [A]
0...299
3
CHN2
1
CHN3
143
CHN4
6
CHN5
Con
fi
guration of the measuring channel 5 with digital measure-
ment values
89:
digital in- and outputs with indication of the function
90:
digital in- and outputs optimized for brake monitoring
91:
digital in- and outputs
92:
DCP command and status bits
0...299 89
12.18 Encoder adjustment menu
Contains parameter values required for aligning the absolute value encoders for synchronous motors.
The procedure for entering the encoder alignment data is described in the "Special functions" chapter.
Parameter Designation Value range
Factory set-
ting
ENC_ADJ
Activating the encoder alignment
Off:
no function
Check:
Activates load-free rotary encoder adjustment check
Load-free:
Activates load-free rotary encoder adjustment
Braked:
Activates rotary encoder adjustment with closed brake
Mag.Adhesion:
Start magnet adhesion process for operation
with Kone EcoDisc type drives.
Mag.Exist.:
Enables replacement of the ZAdyn without carrying
out the magnet adhesion process again with Kone EcoDisc type
drives.
Off
Check
Load-free
Braked
Mag.Adhesion
Mag.Exist.
Off
ENC_POS
Encoder Position
Numerical display of the absolute position of the rotary encoder
per revolution:
0 to [4x number of pulses in rotary encoder] rpm
Cannot be set -
ENC_OFF
Correction value for encoder offset
When performing rotary encoder adjustment with a closed
brake, the offset value is saved in this parameter.
0 ... 360.00
°
0
SAV_P_E
Storing of data in the absolute value encoder via the "Electronic
rating plate" function (only possible with EnDat or Hiperface
absolute value encoders)
ON:
Data from the ZAdyn4C are
fi
led in the absolute encoder
Off:
Function deactivated
On
Off
Off
Original operating instructions
ZAdyn4C
Parameter list
R-TBA12_01-GB 2104 Index 012 Part.-No. 00163371-GB
108/224