8.3.1
Replace the absolute encoder
The replacement of the absolute encoder is described in separate assembly instructions:
Absolute encoder ECN1313 EnDat/ECN1313 SSI
see A-TIA17_02-D/A-TIA17_02-GB
Absolute encoder ERN1387
see A-TIA17_02-D/A-TIA17_02-GB
Absolute encoder AE-S64-BISSC-05-ZA/AE-S64-BISSC-10-ZA
see A-TIA18_03-D-GB
Absolute encoder AE-S64-SinCos-07-AE
see A-TIA20_13-D-GB
8.3.2
Replacement of the brake
The replacement of the brake is described in separate assembly instructions:
Replacement of the brake
see A-TIA21_08-D/A-TIA21_08-GB
8.3.3
Replacement of the traction sheave
The replacement of the traction sheave is described in separate assembly instructions:
Replacement of the traction sheave
see A-TIA19_02-D/A-TIA19_02-GB
8.3.4
Replacement of the bearing bracket
The mounting and dismounting of the magnet rotor and the
fl
ange bearing bracket must only be
carried out by quali
fi
ed personnel and with special devices in the factory.
9 E nclosure
9.1
Technical data
9.1.1
motor
Motor type
ZAtop SM250.45B
Suspension
1:1
2:1
2:1
2:1
2:1
Typical payload*
[kg]
1000
2000
1600
1250
1000
Rated torque
[Nm]
1120
Maximum torque
[Nm]
1800
maximum short circut torque
[Nm]
900 at 30 [rpm]
permissible radial load
[kg]
5890
Speed
[m/s]
1.6
1
1.6
2
2.5
Table 9-1-1
Table shows typical data, other values possible.
* Dependent on travel, compensation ropes may be necessary.
9.1.2
Traction sheaves
- Diameter
[mm]
320
400
400
500
520
600
640
- Width
[mm]
182
150
186
150
150
150
150
Table 9-1-2
Translation of the original operating instructions
ZAtop SM250.45B
Enclosure
A-TBA17_04-GB 2023/28 Index 004 Part.-No. 01013409-GB (EU-BD 760/1)
31/84
