2.6
Work on the device
Information
Mounting, electrical connection, and start-up operation may only be carried out by an electrical
specialist in accordance with electrotechnical regulations (e.g. EN 50110 or EN 60204)!
Danger due to electric current
•
It is generally forbidden to carry out work on electrical live parts. Protection class of the device when
open is IP00! It is possible to touch hazardous voltages directly.
•
The safe isolation from the supply must be checked using a
two-pole
voltage detector.
•
Even after disconnecting the mains voltage, life-threatening charges can appear between the
protective ground
“
PE
”
and the mains connection.
•
The protective earth is conducting high discharge currents (dependent on the switching frequency,
current-source voltage and motor capacity). Earthing in compliance with EN speci
fi
cations shall
therefore be observed even for testing and trial conditions (EN 50 178, Art. 5.2.11). Without
earthing, dangerous voltages can be present on the motor housing.
Waiting period at least 3 minutes!
•
Through use of capacitors, danger of death exists even after switching off the device through
directly touching the energized parts or due to parts that have become energized due to faults.
•
It is only permitted to remove the housing cover after waiting for 3 minutes once the line supply
cable has been shut down. Should measurement or adjustment work be unavoidable on the opened
unit while still powered, then this may only be performed by quali
fi
ed personnel acquainted with the
thereby associated hazards.
Attention!
Even after switching off, dangerous temperatures can still occur in and on the device.
Attention!
Automatically restart after a power failure or mains disconnection!
2.7
Modi
fi
cations / interventions in the device
Attention!
For reasons of safety, no unauthorized interventions or modi
fi
cations may be made on the device. All
planned modi
fi
cations must be authorized by the manufacturer in writing.
Use only genuine spare parts / genuine wearing parts / genuine accessories from ZIEHL-ABEGG.Th-
ese parts were speci
fi
cally designed for the device. There is no guarantee that parts from non-original
sources are designed and manufactured in correspondence with load and safety requirements.
Parts and optional equipment not supplied by ZIEHL-ABEGG are not approved by ZIEHL-ABEGG for
use.
2.8
Operator
’
s obligation of diligence
•
The contractor or owner must also ensure that the electric systems and equipment are operated
and maintained in accordance with electro-technical regulations.
•
The owner is obliged to ensure that the device is operated in perfect working order only.
•
The device may only be used as intended (see
“
Application
”
).
•
You must periodically examine the safety equipment for their properly functioning condition.
•
The assembly instructions and/or operating instructions are always readily available at the location
where the device is being used, are complete and are in legible condition.
•
These persons are regularly instructed in all applicable questions regarding occupational safety
and environmental protection and are knowledgeable regarding the assembly instructions and/or
operating instructions and, especially, are familiar with the safety instructions contained therein.
•
All safety and warning notices attached to the device are never removed and remain legible.
Operating Instructions
Fcontrol
–
model series FXDM
Safety instructions
L-BAL-E072-GB 1642 Index 008
Part.-No.
8/105
