5
Refer to Figure 1 on page 4
Ref. A) (3) Solder Tip Cleaning Tools (Labeled on handle A – B – C)
A 0.75 mm B 0.94 mm C 1.25 mm
Ref. B) Black Filter Housing and Rubber Gasket (Mates to vacuum inlet on ZD-985
Base)
Ref. C) (1) Additional Base Vacuum Filter (One is already in the front of the
vacuum inlet)
Ref. C) (3) Additional Gun Vacuum Filters (One is already in the Solder Capture
Chamber)
Ref. D) (3) Tips (Note: One is already installed on the gun)
Note: All Consumable supplies, and replacement parts are available from:
Memotronics
Phone: (281) 257-8587
E-Mail:
See the “Parts and Accessories” listing on page 18 of the manual for more details.
Setting Up the Unit
Step 1:
Put the black rubber seal into the filter housing. Check to make sure
there is a white felt filter inserted in the front of the black vacuum outlet on the
base unit. Screw the filter housing onto the vacuum outlet. Snug the housing
down but be careful not to over tighten.
