Zetor CRYSTAL HD 150, Руководство оператора

Страница: 178 / 234

No additional interventions may be carried out on electric installation of the tractor
(connection of other electric consumers) due to its possible overloading!
With repairs of electric installation pay special attention in particular to manipulation with the battery
to avoid any contact of electrolyte with skin or clothing.
Basic service information
Accumulator battery
The rechargeable battery must always be wired to the
ground and the 'plus' pole connected to the alternator.
Reversely connected rechargeable battery will destroy the
entire semiconductor device of the alternator. When using
an auxiliary rechargeable battery to start the tractor, be
sure to connect the leads to 'plus' to 'plus' and 'minus' to
'minus'. If the replacement of some charging circuit
components is performed, disconnect the battery from the
tractor ground (-) using the battery disconnect switch. This
eliminates random short circuits on the terminals.
With any manipulation or repair of the starter, it
is necessary to disconnect the battery pole minus the
gearshift lever, including the gearshift lever, to the
neutral so that the lifetime of the repair agent can not
be compromised.
It is forbidden to start by shorting the starter
terminals. Only start the tractor from the driver's seat.
FHD18N099
The accumulator battery is installed under the cover on
the left side of the tractor under the cab step. The battery
is accessible after folding up of the cab step.
During folding up of the cab step the cab door
must be closed.
1 - Remove the screw (1)
2 - Lift the step in the arrow direction
3 - Secure the lifted step with a screw inserted to the
opening (2) in the step
4 - Remove the safety pin (3)
5 - Grasp the bottom edge of the cover and remove it
FHD18N098
ELECTRIC INSTALLATION
177