Zeta Alarm Systems Premier Power Pack, Инструкция по эксплуатации

Страница: 14 / 16

PREMIER POWER PACK INSTRUCTION MANUAL
GLT.MAN-138
PAGE 13
Issue: 1.13 27/7/2012 N.R.P.J.
TECHNICAL INFORMATION
OVERALL SPECIFICATION 5.0 A PSU 2.0 A PSU
MAINS INPUT
Nominal Mains Supply Voltage 230V AC 230V AC
Cage Input voltage range
88
～
132 VAC / 176
～
264 VAC
47
～
63 Hz
；
88
～
264 VAC
47
～
63 Hz
；
AC input current 2.4 A/115 V 1.6A/ 230 V 2.0A/115 V 1.2A/ 230 V
Efficiency 86% 85%
AC inrush current Cold starting current 45A/230VAC Cold starting current 40A/230VAC
Leakage current
＜
2 mA/240VAC
＜
2mA/240VAC
SWITCH MODE CAGE OUTPUT
Nominal DC Output voltage 30V 30V
Output Voltage Error +/- 1% +/- 1%
Output Power 150W 75W
Rated output current @ 30V DC 5 A 2.5 A
Adjustable range for DC voltage 27 – 30.6V 27 – 33V
Setup rise hold up time 800ms,20ms,24ms, Full-load 500ms,30ms,60ms Full-load
PSU OUTPUT
Nominal DC Output voltage 30V 30V
Output Voltage Range 19 – 31 V DC 19 – 31 V DC
Maximum PSU output while charging
I MAX A 4.1A 1.4A
I MAX B N/A N/A
I MIN 0 mA 0mA
Output Fuses 2 x 2.5A 2 x 1.0A
Output Voltage Ripple Typical 120mVp-p (Max 500mV) Typical 150mVp-p (Max 500mV)
Fault Output Normally Energised Volt-Free
Change over Relay: SELV @ 1A Normally Energised Volt-Free
Change over Relay: SELV @ 1A
BATTERY BACKUP
Battery type 2 x 12V Sealed Lead Acid
Batteries connected in SERIES 2 x 12V Sealed Lead Acid
Batteries connected in SERIES
Battery Size Range 7.0 – 17 Ah 2.0 – 12 Ah
Charger Type CPU controlled 3 state charger
(boost, float, pulse modes) CPU controlled 3 state charger
(boost, float, pulse modes)
Boost Charging current 920mA 750mA
Float Charging current 200mA Typical 200mA Typical
Pulse charging 10% duty cycle 10% duty cycle
Battery fuse 5A (in battery link lead) 5A (in battery link lead)
Maximum battery internal resistance 0.9 ohm 2.0 ohm
Battery Deep Discharge Disconnect 20.5 Volts At battery (19V at PSU
output) 20.5 Volts At battery (19V at PSU
output)
Deep Discharge Reconnection When mains restored When mains restored
Charger Temp. Compensation -36mV/
o
C typical (27-46 mV/
o
C) -36mV/
o
C typical (27-46 mV/
o
C)
PSU Battery Drain – in Mains Fail 25mA (40 mA with LCD Screen) 25mA (40 mA with LCD Screen)
Max Battery Monitoring Current (R int test) 460mA 460mA
LED INDICATIONS (PSE and CIE Version)
GREEN Power Steady = Mains OK
Flashing = Mains Fail Steady = Mains OK
Flashing = Mains Fail
General Fault Flashes on Mains Fail or Output
voltage failure Flashes on Mains Fail or Output
voltage failure
Earth Fault Flashes on +VE or –VE earth fault
(if enabled) Flashes on +VE or –VE earth fault
(if enabled)
Battery Fault Flashes on any battery fault. Flashes on any battery fault.