Zero YS-X6, Быстрый старт

Страница: 31 / 60

Copyright(C)2012ZeroUAV All Rights Reserved 31
Motion Compensation
The default value is 80 fit to most crafts. When the sticks back to neutral
position on transmitter, increase the value to get a more stable flying if the
aircraft is shaking heavily. But it will result in high-frequency vibrating if the
number is too big. Setup range:0~255.
Vertical Stable
It is available only in manual mode to increase the comfortable level of THR by
manual, default value 150. The air pressure has big influence on motor stability
when the value is too big. If the air pressure is not stable in windy days, too big
number will affect the comfortable level of THR in manual mode and without
holding altitude.
Max Speed
Setup of maximum flying speed.
Motor arming
Setup of whether to use motor arming to remove throttle protection.
Protection
Setup of whether to enable the THR protection.
Overload control
The acceleration of craft in GPS hover mode can be selected.
Gentle, common and severe are optional.
Notice:
The 4 parameters below need to be filled in when use flight controller for first
time, when filling in the values must make sure the THR stick is in the bottom;
click on “Settings ” � “Enter setting “, when “setting status” displays in “data”
interface you can update the parameters. Then click on “send” to give the
command to autopilot and click on “get” to confirm the update is correct. After
verifying, click on “Settings” � “Exit setting” , the flying can be started.