Zero Motorcycles MX, Руководство пользователя, Страница: 36 / 100

4-7
D C
Installation
1. Slide the power pack into the frame.
2. Connect the power pack connectors.
3. Install the frame rail into the front slot first, then
push the rear side into the frame.
4. Install and securely tighten the knob.
Battery Management System (BMS)
Every power pack contains a Battery Management
System (BMS) which monitors the condition of the
cells and optimizes the charging process to provide
the highest-performance, longest-range, and longest-
life for the power pack.
The BMS also monitors the battery for a host of
predefined conditions, and then takes actions
according to these conditions. Some of these
conditions are listed below. Also see Understanding
Beep Sequences on page 6-3.
•
Low Voltage
Action: When a low voltage is detected the beeper
is sounded to alert the rider that they should stop
riding the motorcycle. This beeper beeps
approximately once every 10-12 seconds when the
motorcycle is being ridden and then once every
minute when the motorcycle is inactive.
•
Dangerously Low Voltage
Action: If the voltage drops to the point that may
damage the battery cells, the power pack sends a
signal to disable the motor controller and the
motorcycle will not run until the voltage returns to
an acceptable level.