Zero 88 Juggler, Руководство по эксплуатации

Страница: 8 / 16

Page 8 Juggler 73-404-00 Issue 1
Sequences
Introduction
A sequence is a series of up to 99 states which are stored in the desk and can be played
back sequentially. Up to 12 sequences may be programmed and stored on the Juggler.
Only one programmed sequence may be played back at a time. A sequence can be
played back manually or automatically. Transitions between the steps can be snap or fade.
The SEQUENCE MASTER fader controls the maximum output level of the sequence.
The LED in the SEQUENCE button indicates the ‘mode’ as follows:
Off = No Sequence Running On = Program Mode Flashing = Playback Mode
The seven segment display shows the selected step number in the sequence. When the
SHIFT key is held down the seven segment display shows the sequence number. The UP
and DOWN buttons are used to change the selected step or sequence number.
If no sequence is being output the seven segment display shows “—“ as an indication that
the desk is powered (there is no separate power LED on the desk).
Programming Sequences
To enter Program Mode – hold down the SEQUENCE button for about two seconds. The
LED in the SEQUENCE button comes on.
Hold down the SHIFT button and use the UP and DOWN buttons to select the required
sequence number (1 – 12). Release the SHIFT button. The seven segment display now
indicates the step number.
Use the UP and DOWN buttons to select the required step number ( 1 – 99).
Use the PRESET A and PRESET B faders to set up the required output levels for the step.
Press the SEQUENCE button to program the selected step. The selected step will
automatically increment to the next step and the LED in the SEQUENCE button will flash
momentarily to indicate that the step was programmed.
Repeat the above procedure for each step to be programmed in the sequence.
Set the SEQUENCE SPEED and FADE TIME controls to the required values for the
sequence.
To exit Program Mode hold down the SEQUENCE button for about two seconds.
The desk returns to Playback Mode and the last selected sequence is started and output.