Zepro ZN 2500-130, Инструкция по установке

Страница: 33 / 68

ZN 2500-130/150 Installation
33 www.zepro.com
2x M12x100 8.8
80 Nm
2x M12x80 8.8
80 Nm
2x M12x80 8.8
80 Nm
2x M12x100 8.8
80 Nm
Image 52. The inner part of the brack -
ets can be fitted at one of four heights
Image 53. The outer part of the brack -
ets can be fitted in one of five positions
Image 54. Fit the beam end caps
Image 55. Installing underrun protection
133
193
241
301
617
667
717
767
817
4.8 Underrun protection
Test the position of the underrun protection without
tightening the bolts to check that the statutory dimen-
sions are obtained. Adjust if necessary then tighten the
bolts with a torque wrench.
1. Fit the inner part of each bracket at one of four
heights. Select the height that meets the statutory
requirements, see section"3.2 Statutory dimensions"
on page 9. Use the correct bolts M12x100. As-
semble without tightening the bolts, see Image 52.
2. Fit the outer part of each bracket at one of five
positions. Select a position that meets the statu-
tory requirements, see section "3.2 Statutory
dimensions" on page 9.
Use the correct bolts M12x80. Assemble without
tightening the bolts. See Image 53.
3. Check that the installation meets the statutory
requirements.
4. Tighten all the bolts using a torque wrench.
Tightening torque: 80 Nm.
5. Fit the beam end caps, rotated so the logo is the
right way up, and press them firmly to secure. If
necessary, tap carefully with a rubber hammer.
m
WARNING!
Check carefully that there is no risk of the outer
part of each bracket colliding with any part of the
cylinders when using the lift’s functions. In particular,
check in relation to the cylinders’ hose connections,
especially when the outer part of the brackets is
installed a long way in.