ZN 2500-130/150
Connection
45
www.zepro.com
6.2
Connection
1. Release and tilt out the relay board.
2. Run the cabling through the grommet.
3. Connect the relevant controller. See Section 6.2.1 - 6.2.2.
4. Where applicable, connect the warning lights. See Section 6.2.3 - 6.2.4.
5. Where appropriate, plug in cab switch (CS) and open platform alarm. See Section 6.2.5 - 6.2.7.
6. Route the cabling on the reverse of the control board / relay board and secure it with cable ties. See Image 78.
7. Tilt in and secure the relay board.
8. Replace the cable grommet, see Section 6.1.2.
Image 78.
Installing cabling with cable ties
NOTE!
The illustration shows the ZePRO1 control card, but the operation is the same regardless of the control card /
relay card model.
IMPORTANT!
Ensure that no cables are pinched or in any other way damaged when the control board is tilted out/in.
IMPORTANT!
Make sure that the control board is disconnected from the power before connecting peripheral equipment. Risk of material
damage.
Содержание ZN 2500-130
Страница 2: ......
