Zepro ZHD 3000-150, Инструкция по установке

Страница: 29 / 37

29
Max 35 mm
~ 10 mm A
8. Installation, continued
NB. Do not adjust the tilt cylinders before they are
installed onto the platform. Tilt cylinders are pre-
adjusted at the factory.
1. Loosen rubber bellows.
2. Assemble only one tilt cylinder in the platform.
3. Tilt up so that the tilt cylinders are extended as
far as the geometry allows. NB. Adjustment should
always be made when the tilt cylinders are fully
pressurized.
4. Firstly adjust the cylinder assembled in the
platform.
5. Loosen 3 pcs. lock screws,
see pict 17
6. Turn the adjustment collar, as per pict 17, so that
the platform fits exactly to the body as per pict 16A.
7. Assemble the other cylinder in the platform.
8. Loosen 3 pcs. lock screws,
see pict 17.
9. Turn the adjustment collar, as per pict 17, so that
the platform fits exactly to the body as per pict 16A.
10. Then adjust both cylinders the last bit alternately
so that the platform fits exactly to the body as per
pict 16 B.
11. Tighten the lock screws. Measure as per in pict
20. NB. Max. 30 mm between the end of the thread
and the adjustment collar. Lock screws torque is
between 3-5 Nm.
Pict. 17
Pict. 16
Pict. 18
Lock screws, 3pcs.
Out
In
Lift model A
3000-150 252 ±5
Pict. 19