GB-7
PSJ2310
G
B
6. Set up
MOUNTING ENGINE
1. Push the shaft tube toward the clutch housing and
rotate it by hand to check that the power transmission
shaft is engaged with the gears.
2. Insert the power transmission shaft housing into the
clutch housing until it bottoms, and align the position-
ing holes on the clutch housing and the shaft tube
and install the screw. When difficult to engage, twist
the engine slightly.
3. Fasten the clamp securely with two screws.
IMPORTANT
Tighten the screws gradually by turns.
CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the
top of the carburetor.
CONNECTING SWITCH WIRES
(1) 3mm or more
• Connect the switch wires between the engine and
the main unit.
• Fix the switch wire like figure of SE3.
• The space between a tank and switch wires is 3mm
or more.
INSTALLING HANDLE
(1) About 48cm
• Install the handle to the shaft tube and clamp it at a
location that is comfortable to you.
JOINT ATTACHMENT
(1)
(1) Knob bolt
• Insert the attachment to the main shaft.
• Tighten the knob bolt securely.
ATTACHING THE GUIDE BAR AND CHAIN
A standard package contains the items as shown be-
low.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(1) Guide bar
(2) Saw chain
(3) Transmission
(4) Sprocket
(5) Chain tension adjust screw
(6) Nut
(7) Chain tensioner pin
(8) Chain cover
Install the guide bar and the saw chain on the transmis-
sion as follows.
WARNING
The saw chain has very sharp edges. Use protective
gloves for safety.
1. Loosen a nut and remove the chain cover.
2. Mount the guide bar then fit the saw chain around
the bar and sprocket.
WARNING
Pay attention to the correct direction of the saw
chain
3. Fit the chain tensioner pin into the lower hole of the
guide bar, then install the chain cover, and fasten the
nut to finger-tight.
(1)
(2)
(3)
(1) Hole
(2) Moving direction
(3) Nut
01-PSJ2310_GB_209＿三.indd 7
12.9.12 1:09:27 PM
