MCC
http://www.zennio.com
Technical Support:
http://support.zennio.com
5
1.2
INSTALLATION
MCC connects to the KNX bus through the on-board KNX connector. Once the device
is provided with power from the KNX bus, both the individual address and the
associated application program can be downloaded.
Figure 1
. MCC - Element Diagram.
The main elements of the device are described next.
Test/Prog. Pushbutton
(1)
: a short press on this button sets the device into
the programming mode, making the associated LED (2) light in red.
Note
:
if this button is held while plugging the device into the KNX bus, the
device will enter into safe mode. In such case, the LED will blink in red.
Master Status LED (3)
: LED indicator that lights up when the device is
running as a master.
Slave Status LED (4)
: LED indicator that lights up when the device is running
as a slave.
Missing Slave LED (5)
: LED indicator that lights up when no slave MCC is
found in the installation. Note that this does not prevent the master MCC from
running normally.
7
1
2
3
4
5
6
1.
Prog./Test Button.
2.
Prog./Test LED.
3.
Slave Status LED.
4.
Master Status LED.
5.
Missing Slave LED.
6.
Configuration Error LED.
7.
KNX Connector.
