MAXinBOX Hospitality
Technical Support:
6
Inputs (1)
: input ports for the insertion of the stripped cables of external
elements such as switches / motion detectors / temperature probes, etc. One
of the two cables of each element needs to be connected to one of the slots
labelled
“1” to “6”, while the other cable should be connected to the slot
labelled
as “C”. Note that all the external input devices share the “C” slot for
one of the two cables. Please secure the connection by means of the on-
board screws.
For detailed information about the technical features of the device and for safety
instructions or about the installation process, please refer to the corresponding
Datasheet
, bundled with the original package of the device and also available at
1.3
START-UP AND POWER LOSS
During the device start-up, the Prog./Test LED will blink
in blue colour
for a few
seconds before MAXinBOX Hospitality is ready. External orders will not be executed
during this time, but afterwards.
Depending on the configuration,
some specific actions
will also be performed during
the start-up. For example, the integrator can set whether the output channels should
switch to a particular state and whether the device should send certain objects to the
bus after the power recovery. Please consult the next sections of this document for
further details.
On the other hand, when
a bus power failure
takes place, MAXinBOX Hospitality will
interrupt any pending actions, and will save its state so it can be recovered once the
power supply is restored. In addition, the individual outputs will switch to the specific
state configured in parameters.
