8
598-1306-07
operation
1. Verify the power disconnect switch is in the ON (right side)
position.
2. Push the ON (top) button and release. The light should turn on
full bright.
Note:
If you are controlling a lamp, make sure it is
connected to the switched outlet and the lamp is switched on.
3. Push the OFF (bottom) button and release. The light should
turn off.
4. Push either the top or bottom of DIM button and release. The
light should turn on at 50% brightness (or last setting).
5. Push and release top of DIM button to increase brightness.
Push and release bottom of DIM button to decrease bright
-
ness.
Note:
There are 5 DIM settings ranging from 15% to 90%
brightness.
6. Set desired DIM level.
Note:
DIM setting remembers last
setting used. To recall last DIM setting from ON or OFF, push
and release either the top or bottom of DIM button.
Note:
The DIM setting defaults to 50% in the event of a power
failure.
NotICE: When the wall switch receiver’s oN button is used
to turn the lights on, oFF commands sent by any transmitter
will be ignored. When the receiver’s oFF button is pushed,
the lights will go off and the receiver will once again accept a
transmitter’s oN/oFF commands.
Bulb replacement
Move the power disconnect switch to the OFF (left side) position.
Replace bulb(s).
CautIoN: do not exceed the maximum load limits
listed above.
Installing Wall Switch Receiver
Wall Switch Screw
Junction
Box
Wall
Switch
ON/OFF Button
DIM Button
Ground Wire (Bare or Green)
Wall
Power Disconnect Switch
Antenna
Wall Plate
Screw
Wall Plate
4. If necessary, strip away 1/2" of insulation from end of wires.
5. Connect one of the black power wires from receiver to one of the
power wires you removed from the old switch. Use one of the
supplied wire connectors to secure the wires (see illustration).
6. Connect the second black power wire from receiver to the other
power wire you removed from the old switch. Use one of the
supplied wire connectors to secure the wires (see illustration).
7. Connect the green ground wire from receiver to the ground
wire removed from old switch. Use one of the supplied wire
connectors to secure the wires (see illustration).
8. Check wire connections to make sure they are secure and that
no bare wires are exposed.
9. Route antenna between the bottom of the junction box and the
wall. Feed antenna into wall cavity while placing wall switch
into junction box.
10. Position the wall switch receiver in the junction box with the DIM
button located to the right. Use the two wall switch screws (long)
supplied to mount the receiver to the wall box (see illustration).
Push excess wiring into wall box while you do this. You may
need to bend the wires to fit inside the box. Mount wall plate on
wall switch receiver with screws (short) provided.
11. Turn on the power to the light switch circuit. Do this at your
circuit breaker or fuse box.
White
(Neutral)
