Cloning Connections/Learning Setup
P A G E 4 3
Connections for the LT2002 Clone Programmer to Learn the L26W58HA Master TV Setup.
Clone Programmer
Master L26W58HA
*Note:
It is assumed that the L26W58HA is connected to a signal source, the source selected is Antenna (RF) In, the signal
is from an Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone
Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV screen, the clone programmer
LED is blinking the required heart beat pattern, see above and next page.
*Note:
Once the clone is connected, do not touch the unit or otherwise disturb it or the MPI connections. Any disturbance
while the clone is operating may disrupt the master setup transfer or copying etc.
Before you begin cloning...
• The Master L26W58HA should be connected to a good, stable
signal from an over-the-air antenna or cable service Analog
channel and connected to power. (See above.)
• Teaching and Learning is only possible between identical model
devices. (However, the LT2002 Clone programmer can store up
to 3 different ‘master’ setups.)
WARNING: Copying a blank or incorrect memory into a TV, STB or
other device will cause the TV, STB or other device to operate
erratically or become inoperable.
• Use an Installer’s remote to operate Learning and Teaching
menus.
• Make sure that the batteries in the Clone programmer are fresh.
• If batteries are removed, the Clone Clock time will be lost.
• Decide if you want to set the time from the Clone programmer
or copy the time to the Clone programmer; from a compatible
TV which has the clock set to the current time.
• Setting the time and transferring it to the Clone or other
device is a separate procedure.
• Follow the connection diagram above to connect the Clone to
a Master L26W58HA TV display panel. After learning is com-
plete, to another identical L26W58HA TV display panel to
“teach” it the master setup.
• After the L26W58HAs setup has been copied to another
identical L26W58HA, that identical unit with the copied setup,
needs to be disconnected from power for about 15 seconds to
activate the newly-copied setup.
• See the Clone Troubleshooting section to resolve problems.
Turn to the next page to continue Cloning Setup.
Ferrite Core
(TDK, ZCAT
2035-0930)
Antenna
or CATV
Warning: Do not use LT2002
if a LodgeNet PPV card is
installed in TV or clone
programmer device will be
damaged.
