INST
ALLA
TION
11
Connections (Continued)
HD Monitor Component (YPbPr) Connections
11
Connect the “Antenna” to the “ANT IN” jack on the HDTV Receiver using a coaxial RF cable.
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the
antenna to the attenuator supplied and screw the attenuator onto the “ANT IN” jack. (Refer to page 9.)
2
2
Connect the “ANT LOOP OUT” jack on the HDTV Receiver to the “Antenna In” jack on your TV using a coaxial
RF cable.
3
3
Connect the “COMPONENT OUT” jacks on the HDTV Receiver to the “COMPONENT IN” jacks of your TV
using RCA-type cables. (The OUTPUT SELECTION switch must be set to YPbPr.)
4
4
Connect the L/R “AUDIO OUT” jacks on the HDTV Receiver to the L/R “AUDIO IN” jacks on your TV using RCA-
type cables.
ote
The component out jacks are available when 480p, 720p, or 1080i display format is selected.
Cable TV
Wall Jack Panel
OR
L
R
Y
Pb
Pr
COMPONENT VIDEO INPUT
AUDIO INPUT
L
VIDEO
INPUT
ANTENNA
INPUT
HD Ready TV Connection Panel
HDTV Receiver Connection Panel
Antenna
