ZENEC ZE-MR1502, Инструкция по эксплуатации

Страница: 28 / 32

28
TROUBLESHOOTING
Problem: Cause
:
Solution
:
No picture when the
display is turned on. 1. Power wire is
connected improperly
or fuse blown.
2. System cable is not
connected properly.
1. Check the power wire
and replace the fuse.
2. Check system cable or
replace with a new one.
Blurred picture on the
screen. 1. Interfered by short-
distanced strong RF
emissions.
(E.g. high voltage wire,
transformation station
or aircraft etc...)
1. The reception of signal
will get better when
moving away from source
of interference.
No function on the
remote control (or
operating distance is
shortened). 1. The battery of remote
control has exhausted.
2. Remote control is
defective.
1. Replace with a new
battery of same rating.
2. Contact with dealer
and replace with a new
remote control.
The picture on the
screen is dark. 1. The monitor is used
at a low temperature
area.
2. BRIGHTNESS is set too
dark.
1. This is the characteristic
of LCD display at low
temperature, it will restore
to normal brightness after
display is in use for few
minutes.
2. Check BRIGHTNESS
adjustment.
No sound can be
heard from the
IR wireless headphone. 1. Headphone is not
switched on.
2. The battery in the head-
phone is low.
3. There is object blocking
the transmitting module
or headphone is beyond
receiving area.
1. Switch on headphone.
2. Replace with a new
battery.
3. Remove the blocking
object or move back to
the receiving area.
ZE-MR1502 Manual D+E_.indd 28 02.02.2006 11:35:09 Uhr