Zelmer ZVC605AQ, Руководство пользователя

Страница: 55 / 56

61
ZVC605-001_v03
PROBLEM ACTION
The suction power of the
vacuum cleaner is weak.
Replace the dust bag and the filters,
check the suction tube, the hose and
the nozzle - remove the cause of the
clogging.
Dust bag full indicator is
activated.
• Dust bag may be full – replace the
dust bag.
• Suction tube or suction head is
clogged – clear all blockages.
The electrical installation
fuse went out.
Check if other appliances are not
plugged to the same electrical circuit
as the vacuum cleaner. If the fuse
goes out repeatedly, return the vacuum
cleaner to a service point.
The vacuum cleaner does
not operate; the housing
or the cord is damaged.
Return the vacuum cleaner to a service
point.
Ecology – Environmental protection
Each user can contribute to protect the environment. It is
neither difficult nor expensive. In order to do so:
Return cardboard packages to recycling
points.
Throw polyethylene (PE) bags into appropriate
containers.
Return a worn out appliance to an appropriate
collecting point as the components of the
appliance may pose a threat to the environment.
Do not dispose the appliance with the municipal waste!
Overheating protection
Models ZVC605AP, ZVC605CA and ZVC605AQ have an
overheating protection device. If will automatically switch off
power to the motor if it overheats. If this happens, turn off
the vacuum by pressing the ON/OFF button (8) . Allow the
vacuum cleaner to cool for approx. 40 min. and switch it on
again. If the vacuum cleaner does not start, return it to an
authorised service agent for repair.
End of operation cleaning
and maintenance
1 Switch off the vacuum cleaner by pressing the
button .
2
Unplug the appliance.
3 Wind the cord by pressing the cord rewind button .
While doing this hold the cord to make sure it is not tangled
and the plug does not hit the vacuum cleaner housing.
4 Disconnect the telescopic tube from the nozzle or brush.
5 Disconnect the telescopic tube from the hose. To remove
the tube from the hose handle simultaneously press the latch
“A” and pull the tube in the direction shown on the picture.
6 Press the two side buttons on the end of the hose and
remove the hose end from the inlet opening of the vacuum
cleaner.
7 The vacuum cleaner may be stored in a vertical or
horizontal position. Put the hook fastening the combination
carpet & floor brush into its clip.
The hose may be attached to the vacuum
cleaner, however you have to make sure that it
is not excessively bent during storing.
8 If necessary, wipe the casing, dust bag compartment and
plastic parts with a damp cloth (washing-up liquid may be
used), let it air dry or wipe it dry.
Do not use abrasive detergents or solvents.
Examples of problems while operating
the vacuum cleaner
PROBLEM ACTION
A characteristic “buzzing”
is heard during
vacuuming indicating the
safety valve operation.
• The dust bag may be full – replace
the dust bag.
• Replace the dust bag even if it is not
full yet. In unfavorable conditions, fine
dust might have clogged the pores on
the surface of the dust bag.
• Suction tube or suction head is
clogged – clear all blockages.
The dust bag is damaged. Remove the dust bag and the filters.
G
The manufacturer does not accept any liability for any damages
resulting from unintended use or improper handling.
The manufacturer reserves his rights to modify the product any time
in order to adjust it to law regulations, norms, directives, or due to
construction, trade, aesthetic or other reasons, without notifying in
advance.