34
ZCM3821-001_v01
●
Remove the drip tray and empty it.
●
Press the drip tray back onto the appliance until it audibly engages.
The
display lights up permanently.
●
Then push
(button
6
).
The following message is displayed:
●
Remove the brewing unit and clean it thoroughly from the inside and from the outside
according to the instructions in chapter “CLEANING THE BREWING UNIT”.
After 10 seconds, the missing brewing unit is indicated by the following message:
●
Replace the brewing unit by turning it into the right position (the outlet tube facing
downwards and to the front), insert the brewing unit into the guide grooves and push it
completely into the coffee machine.
●
Push the coffee grounds container back into the appliance and push the outlet unit into
the upper position. Close the door.
The descaling program is complete when the “Descaling program” function display goes
out.
●
Remove the water tank and fill it with minimum 1 litre fresh water. Replace the water
tank.
The coffee machine is now ready for operation again and returns to the last selected
coffee mode.
Residues of descaler may cause damage to the brewing unit in the long
run! It is imperative that you rinse the brewing unit thoroughly after every
descaling process.
CLEANING THE NOZZLE OF THE MILK FROTHER
To clean the the nozzle of the milk frother, proceed as follows:
●
Push the coffee dispensing unit into the uppermost position.
●
Open the door with the coffee outlet unit by pulling it up on the left side.
●
Pull the milk hose out of the milk frother.
●
Fold the lever on the milk frother upwards and pull the milk frother out towards you.
●
Remove the lid
1
from the milk frother.
●
Remove the milk frother nozzle from the milk frother by inserting the rounded end of
the measuring spoon into the slot of the milk frother nozzle and turning 45° to pull it
out. The nozzle is lifted up slightly during turning so that it can removed more easily.
●
Clean the milk frother nozzle with a thin needle.
●
Mix 200 ml of water with the corresponding quantity of milk cleaning solution. Refer to
the instructions on the cleaning solution for the exact quantity.
●
Leave all parts of the milk frother in the cleaning solution for 5 hours or over night.
Subsequently use the brush of the measuring spoon to clean all parts of the milk
frother nozzle. Make sure that all vents of the milk frother and its nozzle are cleaned
with the brush.
Содержание ZCM3821B
Страница 37: ...ZCM3821 001_v01 ...
Страница 38: ...ZCM3821 001_v01 ...
Страница 39: ...ZCM3821 001_v01 ...
