32
ZCM3821-001_v01
The display “Cleaning program” flashes in the display, while the “Fill water tank” display is
permanently lit.
●
Remove the water tank and fill with min. 1 litre fresh water. Insert the water tank again.
●
Open the lid of the coffee bean container and the coffee powder shaft.
●
Put a cleaning tablet into the coffee powder shaft.
●
Then press
(button
6
).
The appliance will implement several cleaning cycles. After the cleaning phase is
complete, the
display will light up permanently.
●
Remove and empty the drip tray.
●
Press the drip tray back onto the appliance until it audibly engages.
The drip tray serves as collecting container for the cleaning water. You can
alternatively place a container (>350 ml) under the outlet.
●
Then push
(button
6
).
The appliance then initiates the rinsing phase.
The cleaning program is complete when the “Cleaning program” function display goes out.
●
Remove the drip tray and empty it.
●
Press the drip tray back onto the appliance until it audibly engages.
●
Remove the water tank, fill it with clean water and push it back in.
The appliance is now ready for operation again in the last selected coffee mode status.
RUNNING THE DESCALING PROGRAM
The descaling program enables simple and effective descaling of your coffee machine.
You should descale the appliance at regular intervals, but at the latest when the following
indication is flashing on the display:
The descaling process runs in 2 phases, takes approx. 10 minutes and
should not be interrupted.
In case of power failure during the descaling program, it has to be
restarted.
The frequency of descaling depends on the hardness of the water in your
region. Therefore please do not forget to determine the water hardness
and to set the corresponding hardness for the coffee machine! Please refer
to sections “DETERMINING THE WATER HARDNESS” and “SETTING AND
STORING THE WATER HARDNESS” for instructions on this.
Use only recommended descaling agents. If other descaling solutions are
used, manufacturer assumes no liability for any damage caused.
Avoid skin and eye contact.
Rinse off descaling solution with clean water. Obtain medical advice after
eye contact.
Damage to delicate surfaces can occur after contact with the descaling
solution! Remove any splashes immediately.
In order to implement the descaling program, proceed as follows:
●
Press button
2
until the function display “Descaling program” is selected.
●
Then push
(button
6
).
The display “Descaling program” flashes in the display, while the indications
and “Fill
water tank” are permanently lit.
Содержание ZCM3821B
Страница 37: ...ZCM3821 001_v01 ...
Страница 38: ...ZCM3821 001_v01 ...
Страница 39: ...ZCM3821 001_v01 ...
