Zelmer Pluser VC3050.0SK, Руководство пользователя

Страница: 51 / 54

57
VC3050-001_v02
PROBLEM ACTION
The vacuum cleaner works
poorly.
Remove, empty and clean the
CYKLON dust container, replace
filters, check the suction hose, tube
and the nozzle – remove the cause
of clogging.
The electrical installation
fuse went out.
Check if other appliances are not
plugged to the same electrical circuit
as the vacuum cleaner. If the fuse
goes out repeatedly, return the vacuum
cleaner to a service point.
The vacuum cleaner does
not operate; the housing or
the cord is damaged.
Return the vacuum cleaner to
a service point.
Ecology – Environmental protection
Each user can contribute to protect the
environment. It is neither difficult nor expensive.
In order to do so:
Return cardboard packages to recycling
points.
Throw polyethylene (PE) bags into proper
containers.
Return a worn out appliance to a proper collecting point as
the components of the appliance may pose a threat to the
environment.
Do not dispose of with household waste!!!
The manufacturer/importer does not accept any liability for any
damages resulting from unintended use or improper handling.
The manufacturer/importer reserves his rights to modify the product
any time in order to adjust it to law regulations, norms, directives,
or due to construction, trade, aesthetic or other reasons, without
notifying in advance.
End of operation cleaning
and maintenance
1 Switch off the vacuum cleaner by pressing the “on/off”
button (7) .
2 Unplug the appliance.
3 Wind the cord by pressing the cord rewind button (4) .
While doing this hold the cord to make sure it is not tangled
and the plug does not hit the vacuum cleaner housing.
4 Disconnect the telescopic tube from the nozzle or brush.
5 Disconnect the telescopic tube from the hose.
6
Press the side button on the end of the hose, then
remove the end of the hose from the inlet hole of the vacuum
cleaner.
7 The vacuum cleaner may be stored in a vertical position
– just place the fastening hook of the combination brush
into the fastening of the combination brush. The hose may
be connected to the vacuum cleaner. Yet it is necessary to
make sure it is not bent to hard during storing time.
Horizontal storage:
place the fastening hook of the combination brush into
–
its fastening placed at the back of the vacuum cleaner,
near the cord exit.
Vertical storage:
place the combination brush on the telescopic tube,
–
place the fastening hook on the telescopic tube into the
–
fastening of the combination brush placed on the bottom
of the vacuum cleaner, near the front wheel.
8 Clean the housing and the chamber of the vacuum
cleaner with a wet cloth (it may be wet with washing agent),
the dry them or wipe them dry.
Do not use abrasive detergents or solvents.
Examples of problems while operating the
vacuum cleaner
PROBLEM ACTION
The vacuum cleaner has
turned off during operation
– thermal fuse was
activated.
Do not install the CYKLON
dust container until the
vacuum cleaner cools off.
• Turn off the vacuum cleaner, unplug
it and wait ca. 40n minutes before
turning it on again.
• Remove, empty and clean the
CYKLON dust container, as well as
the inlet filter cone and the HEPA inlet
filter.
• Check and clean accessories:
suction hose, tubes, nozzles and
brushes.
• Reassembly all the parts and turn
the vacuum cleaner on.
• If the thermal fuse is activated too
often or the vacuum cleaner will not
turn on after cooling, the vacuum
cleaner should be repaired by
a professional in a service center.
G