51
GW29-033_v01
Installation
1
Make sure all the packaging materials have been removed from the inside of the oven.
2
Remove the protective
fi
lm from the control panel and housing of the microwave oven.
Do not remove the light brown Mica cover which protects the magnetron.
Check for damage such as the curved or warped door, damaged door seals
and sealing surfaces, broken or loosened hinges or latches, dents inside
the microwave oven or on the door.
In case of any damage do not operate the appliance and contact quali
fi
ed
service personnel.
3
Place the microwave oven on an even and stable surface that is strong enough to hold
the oven and the heaviest foods you put in it.
4
The microwave oven is designed for built-in installation only. The microwave oven must
not be placed on the countertop or con
fi
ned in the cupboard.
5
Do not expose the microwave oven to high temperatures and humidity. Do not place
the oven near
fl
ammable materials as well as appliances generating heat.
6
Do not cover or block the ventilation openings. Do not remove the legs.
7
Do not operate without the glass tray and the turntable ring assembly properly installed.
8
Make sure the cord is not damaged, is not placed under the oven or above any hot or
sharp surface and does not hang over the table or counter.
9
Ensure an easy access to the outlet so that it is possible to easily unplug the appliance
in case of emergency.
10
Do not use and store the oven outdoors.
The wall unit build up
1
The cupboard for building in cannot have a back wall behind the appliance.
2
The minimum installation height is 85 cm.
3
Do not cover the ventilation openings and air outlets.
Microwave oven installation
1
Install the oven in the cupboard:
Adjust the height of the A adjustment screw to receive a 1 mm slot between the
●
A adjustment screw and the upper cupboard surface.
Never clench or entangle the cable.
●
2
Open the door, and
fi
x the oven to the cupboard next to the installation opening in the
opening clamp using the C screw.
Grounding instructions
Connect the power cord plug to a mains socket equipped with a grounding prong.
Connection to a socket without a grounding prong will pose the risk of electric shock.
In case of short circuit, grounding reduces the risk of electric shock.
It is advisable to use the oven in a separate electrical circuit.
In case of using an extension cord:
1
The extension cord must be a three-wire conductor with a plug and a socket both
enabling earthed connection.
2
Arrange the extension cord away from hot and sharp surfaces so that it cannot get
accidentally pulled or caught.
Improper connection can result in the risk of electric shock.
In case of any doubts concerning the grounding or electrical mains
connection instructions contact a quali
fi
ed electrician or service centre
employee.
Both the manufacturer and the seller do not accept any liability for injury
or damage to the microwave oven resulting from failure to comply with the
instructions for electrical mains connection.
Radio interference
Microwave oven operation may interference with radio, television or other communication
equipment reception.
Interference can be reduced or eliminated in the following way:
Clean the door and sealing surfaces of the oven,
●
Reorient your radio or TV receiving antenna,
●
Move the microwave oven away from the receiver,
●
Place the microwave oven as far as possible from the receiver,
●
Plug in the microwave oven to a different mains socket so that the microwave oven and
●
the receiver are on different mains circuits.
Height adjustment
A screw
adjustment
Opening clamp
Screw C
Installation
opening
Hint
Tips and information about the product and its use
The microwave oven is intended for household use only.
●
Prick food covered with thick skin such as potatoes, whole marrows, apples and
●
chestnuts before cooking.
Do not overcook food.
●
Check to make sure that the utensils are suitable for use in the microwave oven
●
before using them.
Do not use the microwave oven for storing any objects, such as bread, cakes, etc.
●
Содержание 29Z019
Страница 56: ...GW29 033_v01 ...