62
GW28-016_v01
Burst of steam in vertical position
– Always follow the garment
manufacturer’s ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove wrinkles on
delicate garments in hanging position, hanging curtains, or other hanging
fabrics.
Warning:
Do not apply steam on any clothes or fabrics that are being worn by
human or pets. Never direct the steam to human or pets.
Fill the water tank in as described under “How To Fill Water “.
–
Connect the iron to a suitable mains supply outlet. See „Preparation
–
for operation“.
The red and green
–
control light (6)
glows for a moment and you can
hear single sound signal. Then the
control lights (6)
go off.
Turn the
–
temperature dial
to ●●● position.
The red
–
control light (6)
starts flashing indicating that the iron heater
is on and you can hear a single sound signal.
The red
–
control light (6)
glows and you can hear the sound signal
when the required temperature is reached.
The iron is ready for use.
–
Move the
–
steam control knob (5)
to
position.
Hold the iron between 15 and 30
–
centimetres away from the garment.
Press the
–
burst of steam button (10)
once – steam will shoot from the holes of
the soleplate.
For stubborn wrinkles, wait a few seconds
–
before pressing the
burst of steam
button (10)
again. Most wrinkles can be
removed within three presses.
After operation move the
–
steam control
knob (5)
to
position.
After operation turn the
–
temperature dial
knob (7)
in counter clockwise direction to „
MIN
” position. The iron is
switched off.
Disconnect the iron from mains supply outlet.
–
When the iron gets cool completely, store it vertically in a safe place.
–
It may be necessary to press the burst of steam button a few times
to start this function.
For optimum steam quality, do not operate the burst of steam (10)
more than three times after the control light goes off.
Self-cleaning
This function removes the scales and minerals built up in the steam
chamber. The iron will remain in the best condition if this function is
performed at least once a month or more regularly depending on the
hardness of the water used. Usually after more than 8 hours of operation
it is necessary to perform the
sole plate (1)
self-cleaning, then the
green
control lamp (6)
starts flashing.
Fill the water tank in as described under “How To Fill Water”. Fill it up
–
to the half.
Place the iron on the surface in vertical, resting position.
–
Connect the iron to a suitable mains supply outlet. See „Preparation
–
for operation”.
The red and green
–
control light (6)
glows for a moment and you can
hear single sound signal. Then the
control lights (6)
go off.
Turn the
–
temperature dial (7)
in clockwise direction to ●●● position.
The red
–
control light (6)
starts flashing indicating that the iron heater
is on and you can hear a single sound signal.
The red
–
control light (6)
glows and you can hear the sound signal
when the required temperature is reached.
The iron is ready for use.
–
Wait one cycle; the
–
control light (6)
shall glow and go off.
Turn the
–
temperature dial knob (7)
in counter clockwise direction to
„
MIN
” position. The iron is switched off.
Disconnect the iron from mains supply outlet.
–
Hold the iron horizontally over a sink.
–
Press and hold the
–
self-cleaning knob (2)
.
Steam and boiling hot water will drain from the holes on the soleplate
–
washing away the scales and minerals that have built up inside the
steam chamber.
Gently move the iron back and forth until the water tank is empty.
–
When self-cleaning is complete, release the
–
self-cleaning knob (2).
Rest your iron back on its heel rest and allow to fully cool down.
–
Содержание 28Z023
